After the IP address is changed in the copy destination system, restart OS to check if the IP address is changed properly. Take the following steps:
Cancelling the automatic start suspension of RMS
When cloning the system where GLS is operated by the cluster, cancel the setting that suspends the automatic start of RMS.
# /opt/SMAW/SMAWRrms/bin/hvsetenv HV_RCSTART 1 |
Starting OS in multi user mode
Connect the NIC cable and restart OS in multi user mode.
Checking the IP address
After OS is restarted, check if the changed IP address is enabled. Check if the following procedure is complete.
The changed IP address is set for each physical interface and for each virtual interface.
The changed IP address is set for the monitoring target IP address and the monitoring works properly (in NIC switching mode).
The IP address of the communication target The changed IP address is set for the IP address of the communication target, and the monitoring works properly (in GS/SURE linkage mode).
After RMS is started, the changed takeover IP address is set for the active node of the cluster. After that, when the node is switched, the changed takeover IP address is set for the standby node (in cluster system).
