In GLS, the already configured cluster system can be cloned to configure the new cluster system by changing the IP address.
This chapter explains the procedure of cloning through the examples of the single system for each communication mode and the 1:1 active standby cluster system.
Note
Cloning follows the condition of the cloning software to be used and the cloning function.
Before cloning the cluster system, see the manual "PRIMECLUSTER Installation and Administration Guide" to understand the procedure to change the whole cluster system.
Configuring by cloning
The procedure to configure GLS by cloning is as follows.
Figure E.1 Configuring GLS by cloning
