ETERNUS SF Storage Cruiser V16.5 Operation Guide for Optimization Function

6.4.1 Configuration from FTV Creating Wizard

The procedure for setting the parameters for Automated QoS when creating the FTV from the Web Console is as follows:

1. On the global navigation tab, click Storage.
   The registered ETERNUS Disk storage systems are displayed on the Main pane.

2. On the Main pane, click the target ETERNUS Disk storage system.

3. On the Category pane, click Automated Storage Tiering.
   The items of the Category pane change into the items concerning Automated Storage Tiering.

4. On the Category pane, click FTV.
   The registered FTVs are displayed on the Main pane.

5. On the Action pane, click Create under FTV.
   This proceeds to step 1 of the Creating Wizard.

6. Create an FTV. Refer to "3.6.1 Creation of FTV" for information on items to specify.
   Configure the Automated QoS Priority or the target response time.

7. Click Next.
   This proceeds to step 2 of the Creation Confirmation Wizard.

8. Click Create.
   Operate it as follows. Automatic tuning according to the configured Parameters associated with Automated QoS begins.

   • Newly created FTV should be assigned to a server through host affinity.

   • The performance management function should be restarted after creating a new FTV.
     However, if "All" is specified for the monitored volumes range when starting the performance management function, restarting the performance management function is not necessary.

Note

This section describes the procedure for FTV that is not Virtual Volume. Refer to "Operations for VMware vSphere Virtual Volumes Function" in the ETERNUS SF Web Console Guide for the operation concerning Virtual Volume.