The procedure to change the status of tape library (other than ETERNUS LT250/LT270) is as follows:
On the global navigation tab, click Storage.
On the Category pane, click Tape Library (Manual).
The registered tape libraries are displayed on the Main pane.
On the Main pane, check the target tape library checkbox.
On the Action pane, click Modify under Tape Library.
The information input screen is displayed.
Enter the necessary information, and then click Modify.
Note
Web Console can only change the status of the tape library.
The tape library information cannot be changed using Web Console. In Web Console, input fields of the tape library information are always grayed out.
If you have changed the IP address of a tape library, it is necessary to register a tape library again after deleting it.
