If CF is stopped on the initial connection node, the Cluster Admin main window appears with the CF options of Load driver or Unconfigure (see below).The CF state must be UNLOADED or LOADED to start CF on a node.
Figure 4.12 CF configured but not loaded
Click on the [Load driver] button to start the CF driver with the existing configuration.
The Start CF services pop-up appears (see below.) By default all CF services that have been installed on that node are selected to be started. The contents of this list may vary according to the installed products.
Figure 4.13 Start CF services pop-up
You may exclude CF services from startup by clicking on the selection check box for each service that you do not want to start. This should be done by experts only.
Click on the [OK] button and a status pop-up appears with the results of each service start operation (see below).
Figure 4.14 Start CF services status window
After all the services have been started, click on the [OK] button to return to the Cluster Admin main window.
If you click the [Cancel] button, startup process of the CF services are canceled when these CF services are not yet started.
The already started CF services remain running.
