Systemwalker Desktop Patrol Reference Manual

3.7.2 Messages in Installation

This section describes messages output when setting Systemwalker Desktop Patrol CS and installing AC/ADT.

Failed to write the initialization information.

Type

Error

Cause

Failed to write information into the registry.

Action

Reinstall after restarting PC.

Failed to perform the installation. Please confirm the causes of the failure, and then reinstall.

Type

Error

Cause

An exception occurred during the installation procedure. Or The Cancel option was selected in the installation procedure.

Action

When canceling the installation, reinstall or return to the initial status by uninstalling. But note that the original environment will be deleted when the cancellation is selected during overwriting installation or upgrade installation.

When an exception occurs in the installation, reinstall after confirming the exception content and excluding the causes, or return to the initial status by uninstalling. But note that the original environment will be deleted when the exception occurred during overwriting installation or upgrade installation.

You cannot specify a root directory under a drive in the installation target. Please set the installation target path in a form of adding a drive name and a pathname. (Example: C:\DesktopPatrol\AC <DesktopPatrol is a path name>)

Type

Error

Cause

A root directory under a drive is specified in the installation target.

Action

Set the installation target path in a form of adding a drive name and a pathname

The file system is not NTFS.

Type

Error

Cause

The file system is not NTFS.

Action

Check the PC environment.

The property file registration command of Desktop Master Console does not exist.

Type

Error

Cause

The property file registration command of Desktop Master Console does not exist.

Action

Reinstall after restarting PC.

Failed to register the property file of Desktop Master Console.

Type

Error

Cause

Failed to register the property file of Desktop Master Console.

Action

Reinstall after restarting PC.

Failed to rename the file.

Type

Error

Cause

Failed to rename the file.

Action

Reinstall after restarting PC.

Failed to write the initialization information.

Type

Error

Cause

Failed to write information into the registry.

Action

Reinstall after restarting PC.

The resolution of VGA or higher than VGA is required for this program.

Type

Error

Cause

The resolution may be for unsupported objects.

Action

Reinstall after restarting PC.

Cannot install because the network settings were not configured, or because only IPv6 can be used.

Type

Error

Cause

ADT cannot be installed because the network information of the IPv4 address has not been configured.

Action

Configure the network settings of the IPv4 address, and then install ADT.