Install the HBA address rename setup service using the following procedure.
Before installation, check if "2.4.1 Preparations" have been performed.
Log on to the system as the administrator.
Log on to the system on which the HBA address rename setup service is to be installed using the Administrator account.
Set the first Resource Orchestrator DVD-ROM.
Then, the installer starts automatically.
Information
If the installer does not start, execute "RcSetup.exe" from the DVD-ROM drive.
Select [Cloud Edition].
Click [HBA address rename setup service installation].
The Resource Orchestrator setup window will be displayed.
Check the contents of the license agreement window etc. and then click [Yes].
The [Choose Install Location] window is displayed.
Click [Next>] to use the default Installation Folder. To change folders, click [Browse], change folders, and then click [Next>].
Note
When changing the folders, be careful about the following points.
Do not specify the installation folder of the system (such as C:\).
Enter the location using 100 characters or less. Do not use double-byte characters or the following symbols in the folder name.
""", "|", ":", "*", "?", "/", ".", "<", ">", ",", "%", "&", "^", "=", "!", ";", "#", "'", "+", "[", "]", "{", "}"
When using a 64-bit Windows Server OS, the following folder name cannot be specified for the installation folder.
"%SystemRoot%\System32\"
Folder names including "Program Files" (except the default "C:\Program Files (x86)")
The [Start Copying Files] window will be displayed.
Check that there are no mistakes in the contents displayed on the window, and then click [Install>].
Copying of files will start.
To change the contents, click [<Back].
The Resource Orchestrator setup completion window will be displayed.
When using the HBA address rename setup service immediately after configuration, check the [Yes, launch it now.] checkbox.
Click [Finish] and close the window.
If the check box is checked
The HBA address rename setup service will start after the window is closed.
If the check box is not checked
Refer to "Chapter 6 Settings for the HBA address rename Setup Service", and start the HBA address rename setup service.
Note
Corrective Action for Installation Failure
When installation is stopped due to errors (system errors, processing errors such as system failure, or errors due to execution conditions) or cancellation by users, remove the causes of any problems, and then take corrective action as follows.
Open [Programs and Features] from the Windows Control Panel, and when "ServerView Resource Orchestrator HBA address rename setup service" is displayed, uninstall it and then install the agent again.
For uninstallation, refer to "11.3 HBA address rename Setup Service Uninstallation.
If [ServerView Resource Orchestrator HBA address rename setup service] is not displayed, install it again.
Nullifying Firewall Settings for Ports to be used by Resource Orchestrator
When installing Resource Orchestrator on systems with active firewalls, in order to enable correct communication between the manager, agents, and clients, disable the firewall settings for the port numbers to be used for communication.
For the port numbers used by Resource Orchestrator and required software, refer to "Appendix A Port List" in the "Design Guide CE".
However, when port numbers have been changed by editing the services file during installation of Resource Orchestrator, replace the default port numbers listed in "Appendix A Port List" in the "Design Guide CE" with the port numbers changed to during installation.
