Systemwalker Software Configuration Manager Installation Guide

3.2.3 Post-setup Tasks

This section explains the tasks required after setup for the admin server.

3.2.3.1 Enabling SELinux [Linux]

When temporarily disabling SELinux in "2.2.2 Tasks Required before Installing on the Admin Server" or "3.2.1 Pre-setup Tasks for the Admin Server", execute the following command to enable SELinux.

setenforce 1

3.2.3.2 Starting the Products

3.2.3.2.1 Starting ServerView Resource Orchestrator (If Linking to ServerView Resource Orchestrator)

Start ServerView Resource Orchestrator if linking to it to operate the admin server:

[Windows]

<ServerView Resource Orchestrator installation directory>\SVROR\Manager\bin\rcxmgrctl start

[Linux]

/opt/FJSVrcvmr/bin/rcxmgrctl start

3.2.3.2.2 Starting Systemwalker Software Configuration Manager

Start Systemwalker Software Configuration Manager:

[Windows]

<Systemwalker Software Configuration Manager installation directory>\SWCFMGM\bin\swcfmg_start

[Linux]

/opt/FJSVcfmgm/bin/swcfmg_start

3.2.3.3 Registering Middleware Information

Register the following middleware definitions, which will be used for software parameter management by Systemwalker Software Configuration Manager:

• Definition of software information

• Definition of parameters to be set

• Definition of parameters to be collected

Execute the following command.

[Windows]

<Systemwalker Software Configuration Manager installation directory>\SWCFMGM\bin\swcfmg_setup_mwinfo.bat

[Linux]

/opt/FJSVcfmgm/bin/swcfmg_setup_mwinfo

Note

Execute the command above as an administrator.

It may take more than 15 minutes to complete execution of the command.

See

Refer to "Middleware List" in the Parameter Reference for information on the software and middleware for which information is to be registered.