PRIMECLUSTER Installation and Administration Guide 4.3

7.2.1 RMS Operation

To monitor RMS, RMS needs to be activated.

To stop multiple nodes at the same time, you must stop the user applications and RMS.

Note

To stop two or more nodes at the same time, it is necessary to first stop RMS.

Note that the user application is also stopped when you stop RMS. For instructions on stopping RMS, see "7.2.1.2 Stopping RMS."

The sections below explain how to start and stop RMS.

7.2.1.1 Starting RMS

This section explains how to start RMS.

Operation Procedure:

From the top screen of Web-Based Admin View, open Cluster Admin according to the following procedure:

1. Select Global Cluster Services.

2. Click Cluster Admin to switch to the cluster menu.

3. Select the rms tab.

4. Start RMS.

   1. Use the Tools pull-down menu of the RMS main window, and click Start RMS -> all available nodes. When the confirmation screen is displayed, click Ok.

   2. To specify an option for the RMS start command, click the Option box.

   You can also start RMS on one or all nodes using the command pop-up as follows:

   1. Choose either one node or all the nodes from the pop-up window.

   2. To specify an option for the RMS start command, click the Option box.

See

See "8.1.1 Starting RMS" in "PRIMECLUSTER Reliant Monitor Services (RMS) with Wizard Tools Configuration and Administration Guide."

7.2.1.2 Stopping RMS

This section explains how to stop RMS.

Operation Procedure:

1. Use the Tool pull-down menu on the RMS main window or right-click the system node, and then select the shutdown mode on the screen that appears next.

   1. Choose either a specific node or all the nodes.

   2. Choose to stop all cluster applications, leave the applications running, or forcibly shutdown the node(s).

See

See "8.1.3 Stopping RMS" in "PRIMECLUSTER Reliant Monitor Services (RMS) with Wizard Tools Configuration and Administration Guide."