userApplication Configuration Wizard provides a command for changing the Configuration name ("config") to be used as the default.
You can change the RMS Configuration name to be used by userApplication Configuration Wizard by executing this command in the management server of Web-Based Admin View. For detailed usage instructions, see below.
wgcnfclient-RMS Configuration name setup/reference command
This command allows you to change the RMS Configuration name to be displayed and operated by userApplication Configuration Wizard. As much as possible, the modified information is distributed to all clusters. Normally, the RMS Configuration name does not need to be changed.
To enable this command, the following conditions must be satisfied:
The cluster resource manager package must be installed.
If this package is not installed, the 3-tier configuration of Web-Based Admin View is assumed, and only the information in the local node is changed. If the 3-tier configuration of Web-Based Admin View is being used, this command must also be executed in the secondary management server of Web-Based Admin View.
Resource database installation must be complete.
Open the Cluster Admin CRM main window, then check all the node icons are displayed and green on the CRM tree view.
Changing the RMS Configuration name
As shown below, specify the new RMS Configuration name in the "-o" option and execute the command.
# /etc/opt/FJSVwvucw/bin/wgcnfclient -s config-name -o config2 #
Inquiring the RMS Configuration name
# /etc/opt/FJSVwvucw/bin/wgcnfclient -g config-name config2 #
Since no value is set as the initial value of config-name, no data is displayed until you allocate one.
If this command terminates abnormally, a system command error message may be displayed. If an error message is displayed, respond according to that message.
Note
The RMS Configuration name must be 80 character or less. If the RMS Configuration name has 81 or more characters, RMS Configuration generation and RMS activation will fail.
