This section explains how to install SS.
There are two ways to install SS:
Follow the steps below to install SS using the wizard:
Installation procedure
Insert the Systemwalker Desktop Patrol DVD-ROM in the PC.
In the window below, select SS Installation.
Specify the installation directory.
Once installation is completed, a message prompting the restart of the system may be displayed. Ensure that the system can be restarted, and then proceed according to the message.
Note
Silent installation can only be performed when you are performing installation for the first time.
Installation process must not be interrupted during silent installation.
Follow the steps below to perform silent installation:
Create an installation parameter CSV file.
Refer to "A.3.1 Installation Parameter CSV File" for details.
If you are performing installation using the default values for all parameters, this step is not required.
Use the parameter setup command to create a response file.
Refer to "A.3.2 Parameter Setup Command" for details.
If you did not create an installation parameter CSV file in step 1, this step is not required.
Execute the silent installation command.
Refer to "A.3.4 Silent Installation Command" for details.
Check the installation result in the returned value and message from the silent installation command.
Refer to "A.3 Silent Installation of SS" for details on the files and commands used in, and messages output in silent installation.
