Applicable versions and levels
Windows versions: V5.0L10 or later
Solaris versions: 5.0 or later
Linux versions: 5.2, V10.0L10 or later
Linux for Itanium versions: V12.0L10 or later
HP-UX versions: 5.1 or later
AIX versions: 5.1 or later
DS versions: V20L10
Action 1
Points to check
In the Job net status (*1) group of the Advanced Settings for Event Output window, that is displayed by clicking Details under Event output on the Event output tab in the Define Jobscheduler Startup Parameters window, was the applicable item (Completed/ Pseudo-normal/Started) selected?
*1: On V13.2.0 or earlier, open the Define Jobscheduler Startup Parameters window and specify this setting in the Event output tab.
Action method
In the Job net status check box, select the applicable item (Completed/Pseudo-normal/Started), and then restart the Jobscheduler service/Jobscheduler daemon.
Action 2 [UNIX versions]
Points to check
Was the setting configured so that the user.info information will be output to /etc/syslog.conf?
Are you sending HUP signals for syslogd?
Action method
If the job net is started, completed, or ended pseudo-normally, the facility level of each message output to SYSLOG is user.info.
Configure the setting so that the user.info information is output to /etc/syslog.conf, and send the HUP signal to syslogd.
Note that, to output an info level message to the console or messages file, configure the following settings in syslog.conf:
user.info /dev/console user.info /var/adm/messages |
However, if the above setting was configured, note that all info level messages in the system will be output to the console or messages file.
Information
The facility level of each message output to SYSLOG for the job net status is as follows:
Started:
user.info
Completed:
user.info
Abended:
user.err
Canceled:
user.err
Closed:
user.err
Refused:
user.warning
Skipped:
user.warning
Pseudo-normal:
user.info
