Error message
0225 The job net is being saved or controlled. |
Applicable versions and levels
Windows versions: V5.0L10 or later
Solaris versions: 5.0 or later
Linux versions: 5.2, V10.0L10 or later
Linux for Itanium versions: V12.0L10 or later
HP-UX versions: 5.1 or later
AIX versions: 5.1 or later
DS versions: V20L10
Action
Points to check
Does one of the following apply?
The operation was performed immediately after the operation target job net ended
The same job net was operated at the same time
An operation such as start was performed immediately after the job net was copied
Cause
The Jobscheduler service/daemon or other Jobscheduler command performs processing for the operation target job net while it was being saved or controlled.
This message may be displayed in the job net Completed exit or Abended exit when you try to delete a job net that has itself ended.
Action method
Wait for a while (a few seconds) until the Jobscheduler service/daemon or other Jobscheduler command processing is complete, and then reexecute the operation.
By creating an exit program so that the retry is performed a finite number of times every few seconds, it may be possible to avoid this problem.
