This software supports fault management (SNMP Trap monitoring only) for the CS800.
Connecting to the network
Perform the setup for connecting the CS800 to the network. Refer to the manual which came with the device for details on how to perform the setup.
SNMP Trap setting
Perform the setup of the SNMP Trap transmission destination for the device so that SNMP Traps of the CS800 can be transmitted to the Management Server. If the Management Server is operated in a cluster configuration, set the logical IP address of the cluster as the destination.
Registering the device
Refer to "5.2.6 Registering Manually Embedded Device" for registering the device.
Specify the IP address of the device during the registration operation.
