The procedure to set a DNS server is as follows:
On the global navigation tab, click Storage.
The registered ETERNUS Disk storage systems are displayed on the Main pane.
On the Main pane, click the target ETERNUS Disk storage system.
On the Category pane, click NAS Management.
The items of the Category pane change into the items concerning the NAS Management.
On the Category pane, click Environment Setting.
The NAS environment setting information is displayed on the Main pane.
On the Action pane, click Set DNS Server under Environment Setting.
The Set DNS Server page is displayed.
Item Name | Explanation |
|---|---|
IPv4: Primary IP Address | This is an IPv4 address of the primary DNS server. The input condition is as follows:
|
IPv4: Secondary IP Address | This is an IPv4 address of the secondary DNS server. The input condition is as follows:
|
IPv6: Primary IP Address | This is an IPv6 address of the primary DNS server. The input condition is as follows:
|
IPv6: Secondary IP Address | This is an IPv6 address of the secondary DNS server. The input condition is as follows:
|
Point
It is not possible to set only Secondary IP Address.
A same IP address cannot be set to Primary IP Address and Secondary IP Address.
Enter the necessary information, and then click Set.
Information
If an Active Directory authentication server whose DNS function is enabled is registered to an ETERNUS Disk storage system, name resolution is possible by the use of the DNS function on the Active Directory authentication server. However, in that case, the DNS server information is not displayed on the Web Console.
