2.7.2 Advanced Copy of protected volumes

This section describes Advanced Copy operations for protected logical volumes.

The volume-protected logical volume A can be set as the copy source (backup source).
The volume-protected logical volume B cannot be set as the copy destination (backup destination).

If the copy destination logical volume is protected, an error is output when Advanced Copy is executed.

[Execution example]

> acopc start -g group01

ET001/0x1:ET001/0x6
ccm5007 The target logical volume is write protected. target logical volume=ET001/0x6

  Succeeded : 0
  Failed    : 1

Depending on the volume protection status, the following commands output errors:

"4.7.1 acopc start (OPC/QuickOPC copy start command)"
"4.7.4 acsnap start (SnapOPC+ copy start command)"
"4.8.1 acec start (Synchronous high-speed copy start command)"
"4.8.4 acec resume (Synchronous high-speed copy restart command)"