This section explains the messages output or displayed during the setup of this product.
Description
The cluster setup failed.
Action method
When the setup fails on using the cluster_setup2 command
The NIC settings of the cluster interconnect are not "ONBOOT=YES".
Check that the setting in "/etc/sysconfig/network-scripts", "ifcfg-ethX" (*1) is "ONBOOT=YES", changing "NO" to "YES" if necessary. Then, restart the network interface and re-execute the cluster_setup2 command.
*1: ethX is the network interface used for the cluster interconnect. Specify a numeral at X.
In all other cases
Check the message that was output prior to this message, and take action. Then, perform the cluster setup removal again.
Description
Removal of the cluster setup failed.
Action method
Check the message that was output prior to this message, and take action. Then, perform the cluster setup removal again.
Description
The setup failed at the setup processing shown in $PROCESS.
Action method
When $PROCESS is "PRIMECLUSTER GLS"
The system may not have been restarted after installation. Restart the system, then perform the setup again.
When $PROCESS is other than the above
Refer to the setup log /var/opt/FJSVbdpp/log/bdpp_setup.log, and remove the cause of the error. Then, perform the setup again.
Description
The setup removal failed at the setup removal processing shown in $PROCESS.
Action method
Refer to the setup log /var/opt/FJSVbdpp/log/bdpp_setup.log, and remove the cause of the error. Then, perform the setup removal again.
Description
The slave server definition file "slaves" is not under /etc/opt/FJSVbdpp/conf.
Action method
Create the slave server definition file "slaves", and store it under /etc/opt/FJSVbdpp/conf.
Description
The DFS is not mounted.
Action method
Mount the DFS.
Description
The mount point specified at fstab does not match the BDPP_PDFS_MOUNTPOINT value.
Action method
Check if the mount point specified at fstab is specified for BDPP_PDFS_MOUNTPOINT in bdpp.conf. Change it to the correct value.
Description
Unable to establish a connection between the primary and secondary master server HA clusters.
Action method
Check the following, and take appropriate actions:
Check the connection status of the LAN used for the cluster interconnect, and take action to ensure that it can communicate correctly. Next, execute the cluster_unsetup command and then re-execute the cluster_setup and cluster_setup2 commands.
Check "6.1.2 HA Cluster Setup", and configure and activate the cluster interconnect. Next, execute the cluster_unsetup command and then re-execute the cluster_setup and cluster_setup2 commands.
Description
Unable to connect to an ETERNUS DX disk array.
Action method
Check the following, and take appropriate actions:
Check if there is an error in the IP address specified in the BDPP_DISKARRAY_iSCSI1_IP or BDPP_DISKARRAY_iSCSI2_IP parameters of bdpp.conf in the /etc/opt/FJSVbdpp/conf directory. If an error is found, revise using the correct IP address. Next, execute the bdpp_unsetup command and then re-execute the bdpp_setup command.
Check the connection status of the LAN used to connect to the ETERNUS DX disk array, and take action to ensure that it can communicate correctly. Then, re-execute the bdpp_setup command.
Connect and log in to the target ETERNUS DX disk array. Next, execute the bdpp_unsetup command and then re-execute the bdpp_setup command.
Description
The setup or removal has already been executed.
Description
The user attempting execution does not have root permissions.
Action method
Re-execute using root permissions.
Note
Contact Fujitsu technical staff if an error message other than the ones shown above is output or displayed.
