This appendix describes the definition files for the system configuration information used when building systems or cloning.
Definition files | File overview | Explanation |
|---|---|---|
Configuration file | This file defines the information required for the installation and setup of this product. | |
Slave server definition file | This file defines the slave servers that are the connection targets of the master server. | |
Cloning server definition file | This file is used for Smart Setup. It defines adding slave servers using cloning and deleting slave servers. | |
Network parameter automatic configuration definition file | This definition file is used to configure the network parameter automatically after cloning. | |
Network parameter automatic configuration definition file | This definition file is used to configure the network parameter automatically after cloning. | |
iSCSI initiator configuration definition file | This definition file is used to automatically configure the iSCSI name for each server defined in the ETERNUS DX disk array. |
The definition files are used in environments shown below.
Definition file | Environment | ||||
|---|---|---|---|---|---|
Master server | Slave server | Development server | Collaboration server | ||
Primary | Secondary | ||||
bdpp.conf (*1) | Y | Y | Y | Y | Y |
slaves (*2) | Y | Y | Y | Y | N |
Y (*3) | N | N | N | N | |
Y | N | N | N | N | |
Y | N | N | N | N | |
Y | N | N | N | N | |
Y: Used
N: Not used
*1: A bdpp.conf configuration file is created separately for each server.
*2: The definition of the "slaves" slave server definition file must match across servers. To change this definition, the definition files on the primary master server must be updated, after which the files on the primary master server must be copied to other servers.
*3: This file cannot be used on a master server installed in a virtual environment.
