Follow the procedure below to change (including addition and deletion) the IP address for Management Server transactions.
When an IPv6 address or IPv4 address is added as IP address of the Management Server, step 1 and step 8 are unnecessary.
If, in the Management Server transaction, it is defined as a copy source or copy destination volume with the replication management function, delete the copy source/destination volume settings.
Refer to "Deleting a source volume or replica volume" in the ETERNUS SF AdvancedCopy Manager Operation Guide (for Windows) for information on how to delete the settings.
Stop the Management Server transaction.
Refer to the manual for the cluster software for information on how to stop the transaction.
Change the IP address resource.
Refer to the manual for the cluster software for information on how to change the IP address resource.
Check the operational status of the Management Server transaction. If the transaction is stopped, start up the Management Server transaction.
Refer to the manual for the cluster software for information on how to start up the transaction.
Create the server information change instruction file in a node in which the Management Server transaction is operating.
Run the stgxfwcmmodsrv command with the -f option specified to change the IP address. Refer to "stgxfwcmmodsrv (Server information change command)" in the ETERNUS SF AdvancedCopy Manager Operation Guide (for Windows) for information on the command.
Edit the detailed setting file of the storage management.
Refer to step 4 in "5.1.1.2 Customization for Storage Cruiser's manager" for information on how to edit the detailed setting file.
Restart the Management Server transaction.
Refer to the manual for the cluster software for information on how to stop and start up the transaction.
If using the replication management function, rebuild the replication management environment.
Perform the tasks starting from the section "Configuring the source volume and replica volume" and onwards in the ETERNUS SF AdvancedCopy Manager Operation Guide (for Windows).
Set the SNMP Trap transmission place for each managed device again.
Execute the sanadm chtraprcvip command to set the SNMP Trap transmission place for each managed device again. Refer to "sanadmsh chtraprcvip (SNMP Trap transmission place IP address change command)" in the ETERNUS SF Storage Cruiser Operation Guide for information on the command.
Note
When you change/delete the IP version of the Management Server, perform the following procedures to the Managed Server registered by the IP version before it changes/deletes.
For changing IP version (from IPv4 to IPv6, or from IPv6 to IPv4)
Delete the target Managed Server.
Change the Management Server IP address with the above procedures.
Re-register the target Managed Server with the changed IP version.
For deleting IP version (from IPv4/IPv6 to IPv6 only, or from IPv4/IPv6 to IPv4 only)
Change the target Managed Server IP address to the changed IP version.
Change the Management Server IP address with the above procedures.
