NAME
esfimportdevconf - import the configuration information from the previous version for the devices in the system.
SYNOPSIS
$INS_DIR\Common\bin\esfimportdevconf
($INS_DIR is the program directory specified at the ETERNUS SF Manager installation.)
/opt/FJSVesfcm/bin/esfimportdevconf
DESCRIPTION
A request for the configuration information from the previous version for the devices in the system is issued to this product. OS Administrator permissions are required in order to execute the command.
When the command is executed, this product starts asynchronously to import and convert the configuration information from the previous version.
EXIT STATUS
=0 : Normal end
EXAMPLES
> C:\ETERNUS_SF\Common\bin\esfimportdevconf esccs90000 Operation is accepted.
# /opt/FJSVesfcm/bin/esfimportdevconf esccs90000 Operation is accepted.
NOTES
Check that the targeted devices can be accessed from this product before executing the import command.
Refer to "9.1 Devices supported by the configuration import command" about the devices targeted by the command.
Some configuration information cannot be imported by the configuration import command.
Refer to "9.3 What to do when configuration import is not possible" about the alternative options for these configurations.
Operation is not possible on the targeted devices during the command execution.
Imported configuration information is based on the configuration information that was registered in the previous version. If imported devices do not exist anymore in the new configuration, remove them using the Web Console. To remove a device, refer to "Delete ETERNUS Disk storage system" in the ETERNUS SF Web Console Guide for this version.
Import time for a storage device is approximately 10 minutes. For an estimate of the total import time, do the following calculation:
[Total import time] = number of storage systems x 10 minutes |
The result of the import process is output in the Web Console Operation History. To try again to import the devices for which the import process has failed, execute the [Device re-reading] operation after the message has been output in the Operation History.
Ensure that ETERNUS SF Manager Tomcat service is running before executing the configuration information import command. If it is not running, the configuration information cannot be imported but the execution of the command is issued.
Restart the ETERNUS SF Manager Tomcat service before executing the command again. If the service is not restarted, the message "esccs90010 Operation has already been accepted." is output and the command cannot be executed.
