This section describes the upgrade procedure for Storage Cruiser's agent for RHEL-AS4/RHEL-ES4, HP-UX, or AIX.
The upgrade is performed as follows:
Back up the Storage Cruiser's agent settings information.
No. | Settings information to be backed up | File to be backed up |
|---|---|---|
1 | SNMP Trap sending destination address | /var/opt/FJSVssage/sanm.ip |
2 | Agent definition file | All files under the /etc/opt/FJSVssage directory |
3 | User definition information | /opt/FJSVssage/lib/defusr.dat *1: If there is no file, backing up is not required. |
Uninstall the previous version of the Storage Cruiser's agent.
Refer to "Uninstallation of Storage Cruiser's agent" in the ETERNUS SF Installation and Setup Guide for the relevant previous version for details.
Install this version of the Storage Cruiser's agent.
Refer to "Installation of Storage Cruiser's agent" in the ETERNUS SF Installation and Setup Guide for this version for details.
Set up the Storage Cruiser's agent.
Refer to "Setup of Storage Cruiser's agent" in the ETERNUS SF Installation and Setup Guide for this version for details.
Restore the Storage Cruiser's agent settings information that was backed up in step 1.
Copy the file of No. 1 (in the table above) and create /var/opt/FJSVssage/sanm.ip.
Refer to each file of No. 2 (in the table above) and reflect the definitions which have been changed from the installation of the previous version of Storage Cruiser's agent to the /etc/opt/FJSVssage directory.
Migration is not required for files whose definitions have not been changed. Use the new definition files.
Copy the file of No. 3 (in the table above) and create /opt/FJSVssage/lib/defusr.dat.
This is not required if the file was not backed up in step 1.
Reload the server information using the Web Console.
See
Refer to "Reload the server configuration information" in the ETERNUS SF Web Console Guide for this version for information on reloading server information.
The upgrade of Storage Cruiser's agent for RHEL-AS4/RHEL-ES4, HP-UX, or AIX is completed.
See
If you want to change the IP address after upgrading, refer to the following sections in the ETERNUS SF Storage Cruiser Operation Guide:
For RHEL-AS4/RHELES4, see "Changing the IP address of a server node (host)" in "[Linux Version] Maintenance of Agent"
For HP-UX, see "Changing the IP address of a server node (host)" in "[HP-UX Version] Maintenance of Agent"
For AIX, see "Changing the IP address of a server node (host)" in "[AIX Version] Maintenance of Agent"
