This section describes a configuration setup example for the following network configuration.
[Setting up domain-0 (host OS)]
On the host OS, set up the virtual bridge (xenbrX) for the physical interface (ethX).
[Setting up the guest domain1 (active node)]
Setting up GLS is the same as for "B.7.3 Example of the Cluster system (1:1 Standby)".
[Setting up the guest domain2 (standby node)]
Setting up GLS is the same as for "B.7.3 Example of the Cluster system (1:1 Standby)".
[Setting up the cluster interconnect]
For information on the settings of the virtual switch required for connecting clusters, see "PRIMECLUSTER Installation/Administration Guide".
