This section describes a configuration setup example for the following network configuration.
[Setting up domain-0 (host OS)]
The GLS for the host is the same as the one described in "B.4.1 Example of the Single system without NIC sharing". Note that you do not need to create the settings to have GLS recognize the virtual network configuration.
[Setting up the guest domain1 (active node)]
Setting up GLS is the same as for "B.4.7 Example of the Cluster system (1:1 Standby)".
[Setting up the guest domain2 (standby node)]
Setting up GLS is the same as for "B.4.7 Example of the Cluster system (1:1 Standby)".
[Setting up the cluster interconnect]
For information on the settings of the virtual switch required for connecting clusters, see "PRIMECLUSTER Installation/Administration Guide".
