For operation of the Managed Server, port numbers must be specified.
This information reflects the port number that was entered during installation of AdvancedCopy Manager's agent, in "Port Registration" screen to the services file. Check that the setting for the specified port number is applied, and that the port number is not in use for other purposes.
#Service name Port number/protocol name stgxfws 1226/tcp
Point
If the specified port number is already in use for other purposes, edit the <Windows installation directory>\system32\drivers\etc\services file manually and change to an unused port number.
The table below shows the intended purposes of port numbers. If settings for port filtering are required, refer to the information stated in the "Purpose" column to check the objects to be connected to the ports before you make the settings.
Service name | Reception port | Purpose |
|---|---|---|
Communication service | 1226/tcp | Used for the followings:
|
Communication service for cluster transactions | Any-number/tcp |
NOTE: In a clustered system, this service is required for each transaction that is created during the cluster setup. The reception port is any port number that was specified for that transaction.
Note
If, when you installed AdvancedCopy Manager's agent, you entered a port number other than the default one, replace the port number listed above by the one you actually entered.
Prepare the port numbers to be used on the Managed Servers and enter them into the /etc/services file.
The table below shows the intended purposes of port numbers. If settings for port filtering are required, refer to the information stated in the "Purpose" column to check the objects to be connected to the ports before you make the settings.
Service name | Reception port | Purpose |
|---|---|---|
stgxfws | 1226/tcp | Used for the followings:
|
stgxfws_logical_node_name | Any-number/tcp |
NOTE: In a clustered system, this service is required for each transaction that is created during the cluster setup. The logical_node_name is the name that was specified during the cluster setup, and the reception port is any port number that was specified for that transaction.
Enter the service name, the port number to be used, and the protocol name into the /etc/services file.
The example below shows how to set "1226" for the port number to be used.
#Service name Port number/protocol name stgxfws 1226/tcp
Point
If the specified port number is already in use for other purposes, change to an unused port number.
