6.2.1 Setting up user account

AdvancedCopy Manager commands can only be executed by users with administrator privileges for the operating system.

This section explains how to create accounts for users who can execute commands.

Point

By assigning a user account created here to an ETERNUS SF role group, you can enable the same user to both operate from the Web Console and execute commands.

For Windows Server 2003

For using AdvancedCopy Manager commands, operate as a user with Administrator permissions or a user in the Administrators group.

For Windows Server 2008 or later

In Windows Server 2008 or later, a User Account Control function (hereafter called "UAC") has been added to enhance security.
The cases where UAC is enabled and disabled are explained below.

When UAC is enabled
When any user other than the built-in Administrator account (including accounts in the Administrators group) executes a process or program that requires administrator permissions, the "Permissions granted/authorized dialog" is displayed. Permissions granted or authorized must be confirmed.
When UAC is disabled
Processes or programs that require administrator permissions must be executed by either the built-in Administrator account or a user account in the Administrators group.

The operating conditions are shown below.

Table 6.1 Relationship between account and UAC
Account type	UAC: Enabled	UAC: Disabled
Built-in Administrator account	A	A
User account in the Administrators group	B	A
Standard user account	B	C

A: Runs without displaying the permissions granted dialog.
B: Displays the permissions granted dialog, and runs if permissions are approved.
C: Does not run, because Administrator permissions cannot be obtained.

If you do not wish to perform the dialog process using the administrator permissions dialog, and the conditions marked as "B" in the table above apply (for example, in batch processing), the program must be executed using administrator permissions with one of the following methods:

In the Command Prompt, use "runas" command to execute the program as a user with administrator permissions. A password must be entered after this.
[Batch file (test.bat) execution example]
```
runas /noprofile /user:mymachine\acmuser "cmd.exe /k test.bat"
```
In the Task Scheduler, specify "Execute with top level privileges" to operate the program.
Execute the program with the Command Prompt.
- For Windows Server 2008 or Windows Server 2008 R2
  From the [Start] menu, select [All Programs]-[Accessories] and right-click on [Command Prompt]. Specify "Run as Administrator" to run the Command Prompt. Execute the program from the Command Prompt.
- For Windows Server 2012
  Specify "Command Prompt (Admin)" to run the Command Prompt. Execute the program from the Command Prompt.

6.2.1 Setting up user account

6.2.1.1 Creating user accounts for executing command

6.2.1.2 User account of Linux/Solaris