3.7.2 Changing Input Values Set in the Automatic Operation Process

The following settings are required for the automatic operation process:

User-defined attributes

Values must be set in the user-defined attributes of the automatic operation process. Enter values as shown below.

Table 3.5 Automatic operation process user-defined attributes
User-defined attribute name	Input value	Use
smtp_server	Host name or IP address of the mail send (SMTP) server	Used as the hostname parameter value of the operation part that sends error mail
from_address	Error mail send source address	Used as the fromaddress parameter value of the operation part that sends error mail
to_address	Error mail send destination address	Used as the toaddress parameter value of the operation part that sends error mail
hostname	Host name or IP address of the server targeted for operation confirmation	Used as the hostname parameter value of the operation part that confirms the power supply status and the operation part that confirms the operating status
event_manager	Host name or IP address of the operation management server	Used as the hostname parameter value of the operation part that confirms event issue
event_message	Event message character string used to confirm that the system is operating normally	Used as the eventmessage parameter value of the operation part that confirms event issue
manager_server	Web console URL host name to be coded in the mail text to be sent	Used to code the Web console URL in the text parameter value of the operation part that sends error mail

Operation part input information

If required, set a parameter value as input information for the following operation part:

Enter parameter values as shown below.

Table 3.6 Operation part input information
Operation part name	Parameter name	Input value
Send error mail 1-3	smtpusername (*1)	User name for SMTP authentication to the host of the mail send (SMTP) server
Send error mail 1-3	smtppassword (*1)	User password for SMTP authentication to the host of the mail send (SMTP) server

*1:
Set this parameter in environments that require authentication to the SMTP server when mail is sent.

Delay node timer value

Set times for the delay node timers, as required. The settings contents are shown below.

Table 3.7 Timer settings information
Name	Timer name	Settings value
Delay_morning	morningtimer	The time when operation confirmation is to be performed. "09:00" is set as the default.
Delay_afternoon	afternoontimer	The time when operation confirmation is to be performed. "12:00" is set as the default.
Delay_evning	eveningtimer	The time when operation confirmation is to be performed. "18:00" is set as the default.

See

Refer to the Systemwalker Runbook Automation Studio User's Guide for the method for changing automatic operation processes.