The procedure for manager installation is given below.
Before installation, check if "2.1.1 Preparations" have been performed.
Log in to the system as the OS administrator (root).
Boot the admin server that Resource Orchestrator is to be installed on in multi-user mode, and then log in to the system using root.
Set the first Resource Orchestrator DVD-ROM and execute the following command to mount the DVD-ROM. If the auto-mounting daemon (autofs) is used for DVD-ROM auto-mounting, the installer fails to start due to its "noexec" mount option.
# mount -t iso9660 -r /dev/hdc DVD-ROM_mount_point <RETURN> |
Execute the manager installation command (the RcSetup.sh command).
# DVD-ROM_mount_point/ RcSetup.sh <RETURN> |
Select "1. Manager(Virtual Edition) installation".
Perform installation according to the installer's interactive instructions.
Enter the parameters prepared and confirmed in "Parameters Used for Installation" in "2.1.1.2 Collecting and Checking Required Information".
Note
Current Directory Setting
Do not set the current directory to the DVD-ROM to allow disk switching.
In Single User Mode
In single user mode, X Windows does not start, and one of the following operations is required.
Switching virtual consoles (using the [Ctrl] + [Alt] + [Fn] keys)
Making commands run in the background
Corrective Action for Installation Failure
In the event of installation failure, restart the OS and then log in as the user that performed the installation, and perform uninstallation following the uninstallation procedure.
After that, remove the cause of the failure referring to the meaning of the output message and the suggested corrective actions, and then perform installation again.
If there are internal inconsistencies detected during installation, the messages "The problem occurred while installing it" or "It failed in the installation" will be displayed and installation will fail. In this case, uninstall the manager and reinstall it. If the problem persists, please contact Fujitsu technical staff.
Nullifying Firewall Settings for Ports to be used by Resource Orchestrator
When installing Resource Orchestrator on systems with active firewalls, in order to enable correct communication between the manager, agents, and clients, disable the firewall settings for the port numbers to be used for communication.
For the port numbers used by Resource Orchestrator and required software, refer to "Appendix A Port List" in the "Design Guide VE".
However, when port numbers have been changed by editing the services file during installation of Resource Orchestrator, replace the default port numbers listed in "Appendix A Port List" in the "Design Guide VE" with the port numbers changed to during installation.
Uninstall the Related Services
When locating ServerView Deployment Manager in the same subnet, it is necessary to uninstall the related services.
For the method for uninstalling the related services, please refer to "5.1 deployment_service_uninstall" in the "Reference Guide (Command) VE".
Destination Directories
The destination directories are fixed as those below and cannot be changed.
/opt
/etc/opt
/var/opt
/root/InstallShield
