The procedure for manager installation is given below.
Before installation, check if "2.1.1 Preparations" have been performed.
Installation
The procedure for manager installation is given below.
Log on as the administrator.
Log on to the system on which the manager is to be installed.
Log on using the Administrator account.
Start the installer.
The installer is automatically displayed when the first DVD-ROM is set in the DVD drive. If it is not displayed, execute "RcSetup.exe" to start the installer.
Click "Manager(Virtual Edition) installation".
Following the installation wizard, enter the parameters prepared and confirmed in "Parameters Used for Installation" properly.
Note
Advisory Notes for Changing the Installation Folder
Enter the location using 45 characters or less.
When installing this product on Windows 2003 x64 Edition or Windows 2008 x64 Edition, the "Program Files" folder cannot be specified for the installation folder.
In the event of installation failure, restart and then log in as the user that performed the installation, and perform uninstallation following the uninstallation procedure.
After that, remove the cause of the failure referring to the meaning of the output message and the suggested corrective actions, and then perform installation again.
If there are internal inconsistencies detected during installation, the messages "The problem occurred while installing it" or "Native Installer Failure" will be displayed and installation will fail. In this case, uninstall the manager and reinstall it. If the problem persists, please contact Fujitsu technical staff.
Nullifying Firewall Settings for Ports to be used by Resource Orchestrator
When installing Resource Orchestrator on systems with active firewalls, in order to enable correct communication between the manager, agents, and clients, disable the firewall settings for the port numbers to be used for communication.
For the port numbers used by Resource Orchestrator and required software, refer to "Appendix A Port List" in the "Design Guide VE".
However, when port numbers have been changed by editing the services file during installation of Resource Orchestrator, replace the default port numbers listed in "Appendix A Port List" in the "Design Guide VE" with the port numbers changed to during installation.
