The replication function is used to restore a system volume.
Figure D.4 Restoring a system volume
The restoration procedure is as follows:
Stop the restoration target server.
After the server stops, check that the server power is off.
If the system volume on the restoration target server is unusable because of a hardware failure, recover the system volume so that the data can be restored.
On the server used for restore operations, execute swsrpmake (Replication creation command) with replication in the reverse direction.
# /opt/FJSVswsrp/bin/swsrpmake -m SBKVOL@SBK-SV SYSVOL@TRG-SV |
(*) The command operand was specified in the format "volume name@Managed Server name", as shown in the examples below.
name of backup/restore target server: TRG-SV
name of system volume: SYSVOL
name of server that performs the backup/restore operation: SBK-SV
name of backup volume: SBKVOL
Activate the restoration target server.
