The procedure to reload the ETERNUS Disk storage system configuration information is as follows:
On the global navigation tab, click [Storage].
The registered ETERNUS Disk storage systems are displayed on the Main pane.
On the Main pane, check the target ETERNUS Disk storage system checkbox.
On the Action pane, click [Reload Conf.] under the [Storage].
Point
ETERNUS SF Manager updates the displayed information, obtaining the information from the ETERNUS Disk storage system section by section. If any of the situations below have occurred, perform the above-described operation to display the up-to-date information.
Changed the configuration using ETERNUS Web GUI.
Changed the configuration using CLI.
Check the status of the constituted elements because of trouble in the ETERNUS Disk storage system.
Clear the Error status after the recovery because of trouble in the ETERNUS Disk storage system.
Note
The reloading of ETERNUS Disk storage system configuration information may take from a few minutes to over 10 minutes depending on the device configuration. "4.21.1 Display the operation history" allows you to confirm the completion of ETERNUS Disk storage system configuration information reloading. The ETERNUS Disk storage system configuration information reloading has completed when the displayed items of the Operation History screen is as follows:
Action : Reload Configuration on Disk Array
State : Complete
Result : Success
Target : Name of the registered ETERNUS Disk storage system
Please do not perform any operation for this ETERNUS Disk storage system until the configuration information reloading has been completed.
