ETERNUS SF Express V15.1/ Storage Cruiser V15.1/ AdvancedCopy Manager V15.1 Web Console Guide

4.3.9 Assign ETERNUS Disk storage system volumes to a server

The procedure to assign volumes of ETERNUS Disk storage system to a server is as follows:

1. Select Server

2. Select HBA and Port

3. Assign Volumes to the Server

   
   

The procedure to assign volumes of ETERNUS Disk storage system to a server is as follows:

1. On the global navigation tab, click [Storage].
   The registered ETERNUS Disk storage systems are displayed on the Main pane.

2. On the Main pane, check the target ETERNUS Disk storage system checkbox.

3. On the Action pane, click the [Assign Volume] under the [Wizard].

4. Click the [Next] button on the lower right.

5. Click the target server radio button.

6. Click the [Next] button on the lower right.

7. If you set the zoning, check "Yes" of the [Zoning Setting] radio button.
   Only when the license of ETERNUS SF Storage Cruiser Standard Edition is registered, the [Zoning Setting] radio button can be checked.

8. Click the target HBA checkbox.

9. Click the [Connect] button to select a port of the ETERNUS Disk storage system to be connected.

10. Click the [Next] button on the lower right.

11. Select a volume to be assigned in either of the following tabs.

    • [Select Volume] tab

    • [Select Affinity/LUN Group] tab
      Only when the license of ETERNUS SF Storage Cruiser Standard Edition is registered, this tab can be clicked.

    When using the [Select Volume] tab:

    1. Check the target volume checkbox to be added from the volume list.

    2. Click the [Add] button.

    When using the [Select Affinity/LUN Group] tab:

    1. Check the target Affinity/LUN Group radio button to be assigned from the Affinity/LUN Group list.

12. Click the [Assign] button on the lower right.

Note

If volume assignment fails, it is possible that the zoning was partially successful. The failure may be due to a temporary communication problem. Retry the volume assignment.