This section explains the system configuration necessary when using RHEL5-Xen as server virtualization software.
Example of System Configuration
An example system configuration using RHEL5-Xen is given below.
Figure E.18 System Configuration Example Using RHEL5-Xen
*1: For details on required software, refer to "1.4.2.2 Required Software".
Network Configuration Example
An example network configuration using RHEL5-Xen is given below:
Figure E.19 Virtual Bridge Settings Using Network Resources
L-Server Creation Procedure
Use the following procedure to create L-Servers:
Figure E.20 Resource Orchestrator Setup Procedure
For details on pre-setup preparations, refer to "E.4.2 Preparations".
For details on how to install Resource Orchestrator, refer to "E.4.3 Installation".
For details on how to set up Resource Orchestrator, refer to "E.4.4 Setup".
For details on how to create an L-Server, refer to "L-Server Creation" of "E.4.4 Setup".
