Set up hardware
Set up hardware required for PRIMECLUSTER.
Install software
Install PRIMECLUSTER first, referring to the “PRIMECLUSTER Installation Guide”.
Then, install NetWorker Wizard following the instructions of the “PRIMECLUSTER Wizard for NetWorker Installation Guide”.
Standby operation requires the PRIMECLUSTER Enterprise Edition or PRIMECLUSTER HA Server or PRIMECLUSTER Clustering Base or PRIMECLUSTER Lite Pack.
Configure a cluster system
Configure a cluster system including network systems and shared disk units according to the PRIMECLUSTER manual.
Setting Shared Disk Device
A shared disk that is shared between cluster nodes must be defined to construct NetWorker cluster environment.
Information
How to set up shared disk, see “PRIMECLUSTER Installation and Administration Guide”.
Note
Do not specify “/nsr" for a mount point of a shared disk.
/etc/vfstab file
Define disk mount information that is shared by cluster application.
Setting network
To setup cluster environment on NetWorker, use takeover IP address as takeover network.
Information
How to set up network, see “PRIMECLUSTER Installation and Administration Guide”.
/etc/hosts file
Define the logical node name that corresponds to the takeover IP address.
