This chapter describes the information specified to Express to install and operate a storage system.
The following is the information specified to Express.
Information specified to Express | Item | For installation | During operation | |
|---|---|---|---|---|
Name | A | B | ||
Alias | B | B | ||
HBA Type | A | C | ||
Host ID1 (Note1) | A | B | ||
Host ID2 (Note1) | B | B | ||
Name | C | B | ||
Alias | B | B | ||
IP address or FQDN | A | B | ||
SNMP Community Name | A | B | ||
Username | A | B | ||
Password | A | B | ||
Encryption Mode | B | B | ||
"A.3 Volume Information" (Note2) | Name | A | C | |
Alias | B | C | ||
Size | A | C | ||
Type | A | C | ||
Source Volume Size | B | C | ||
Number of Volumes | A | C | ||
Encryption | B | C | ||
RAID Level | B | C | ||
"A.4 RAID Group Information" (Note2) | Name | A | C | |
RAID Level | A | C | ||
Assigned CM | A | C | ||
Disk Selection | A | C | ||
Number of Disks | A | C | ||
Configuration of Advanced Copy | A | B | ||
Configuration of Remote Advanced Copy | B | B | ||
SMTP server | A | B | ||
Mail Sender | A | B | ||
SMTP Port | A | B | ||
Person in Charge | A | B | ||
Phone | A | B | ||
A | B | |||
Send Event Notification Email | B | B | ||
For FC connection | Connection | B | B | |
Loop ID | B | B | ||
Transfer Rate | B | B | ||
Host Affinity | B | B | ||
Host Response | B | B | ||
For iSCSI connection | IP Address | A | B | |
Subnet Mask | B | B | ||
Default Gateway | B | B | ||
iSCSI Name | A | B | ||
Alias Name | B | B | ||
Host Affinity | B | B | ||
Host Response | B | B | ||
For SAS connection | Host Affinity | B | B | |
Host Response | B | B | ||
Events | B | B | ||
Login/Logout History | B | B | ||
Configuration Change History | B | B | ||
Screen Refresh Interval | B | B | ||
A : Item that is required.
B : Item that can be added/changed.
C : Item that cannot be changed.
Note 1 : "Host ID1" and "Host ID2" are changed by the "HBA Type".
When "HBA Type" is FC or SAS:
HBA#1WWN
HBA#2WWN
When "HBA Type" is iSCSI:
HBA#1iSCSI Name
HBA#1IP Address
HBA#2iSCSI Name
HBA#2IP Address
Note 2 : Volumes and RAID groups, can be created and deleted during operation, however these settings can not be changed after creating the volumes and the RAID groups.
