When adding a Fujitsu ETERNUS storage system to the current ETERNUS environment, change the settings on the Tape Server as follows. This section describes changing the settings when various changes are made.
Create an access path partition for the added Fujitsu ETERNUS storage system.
For details, refer to "Creation of Access Path Partition" in the "ETERNUS SF AdvancedCopy Manager Installation Guide".
Edit the /etc/opt/FJSVswstm/conf/devpath.conf file to add the access path of the added Fujitsu ETERNUS storage system.
For details, refer to "Setting Access Path Definition Files" in the "ETERNUS SF AdvancedCopy Manager Installation Guide".
Execute "11.4.1 tbochkconf (Tape Server definition file check command)".
When ETERNUS DX60/DX80/ETERNUS2000/ETERNUS3000/ETERNUS4000 disk array unit has been added, follow the procedure below in accordance with the type of multi-path driver installed in the Tape Server:
If the ETERNUS multi-path driver is installed
Execute "11.4.13 tbogetoluinfo (ETERNUS DX60/DX80/ETERNUS2000/ETERNUS3000/ETERNUS4000 information acquisition command)" with the IP address of the added ETERNUS DX60/DX80/ETERNUS2000/ETERNUS3000/ETERNUS4000 disk array unit.
# /opt/FJSVswstm/bin/tbogetoluinfo -l 200.30.40.30 200.30.40.30 comleted. [total olu = 100] The configuration file of CM information was update. # |
If the GR multi-path driver is installed
Execute "11.4.13 tbogetoluinfo (ETERNUS DX60/DX80/ETERNUS2000/ETERNUS3000/ETERNUS4000 information acquisition command)" with the IP address of the added ETERNUS DX60/DX80/ETERNUS2000/ETERNUS3000/ETERNUS4000 disk array unit.
# /opt/FJSVswstm/bin/tbogetoluinfo -l 200.30.40.30 200.30.40.30 completed. [total olu = 100] /var/opt/FJSVmplb/mplb_ext.conf was update. # |
Execute the command below to read information to the GR multi-path driver.
This command need not be executed if the ETERNUS multi-path driver is installed in the Tape Server.
# mplbconfig -q # |
Note
This command should not be executed while the RAID device is processing the migration.
