The procedure for installing Agents is described below.
The CD-ROM "ETERNUS SF Storage Cruiser 14.0 Manager/Agent (Linux, VMware)" is used in the installation of Agents.
The agent is installed on the VMware ESX Server Service Console.
Login with Administrator Operating System (root) to VMware ESX Server Service Console.
Check that this software (old version, level etc.) is not installed.
# cd CD-ROM_mount_point/agent/RHEL
# ./scagtinstall.sh -checkIn the event that the message is output as a result of the above operation, take action as follows
If ETERNUS SF Storage Cruiser Agent package has been installed
Refer to the exclusive software's document, and uninstall it.
Refer to "7.5.1 Stopping agent", and after stopping agent please uninstall the output package.
Installation time for this software is around 5 minutes.
Login as the super user (root) by the following command.
# su
After performing the procedures in "6.5.3.1 Pre-installation preparations", move to the directory storing the scagtinstall.sh command.
# cd CD-ROM_mount_point/agent/RHELExecute the scagtinstall.sh command.
# ./scagtinstall.sh
The following message is output. To execute installation enter "y", to discontinue the installation enter a different character.
ETERNUS SF Storage Cruiser 14.0 Copyright FUJITSU LIMITED 2006-2009 This program will install "ETERNUS SF Storage Cruiser" Agent on your system. Do you want to continue the installation of this package? [y,n,?,q]
Enter "y" and the installation will commence.
An example of the displayed information is given below.
INFO : Starting Installation of ETERNUS SF Storage Cruiser ... INFO : Installation of <FJSVssage> was successful. ...
When installation is completed normally, the following message will be displayed.
INFO : ETERNUS SF Storage Cruiser Agent was installed successfully.
If there is an error during installation, the following message will be displayed.
ERROR : not privileged or INFO : Installation is terminated. or ERROR : Installing FJSVssage was failed.
If the installation fails, check the install status using the following command.
# rpm -qi FJSVssage
If the installation was successful, the package information will be displayed. If any error message is displayed, refer to "7.5 [VMware] Uninstallation", delete this software and reinstall it.
The installation is completed. Continuously, execute the post-installation setup by referring to "6.5.4 Post-installation setup".