PRIMEQUEST System Disk Mirror for Windows User's Guide V1.0

B.2 Service Messages

This section describes service messages and explains what to do in response to the messages.

 

Message output and viewing

Service messages are output to the Windows event log.

The event log can be viewed in Windows Event Viewer.

To open Event Viewer, select [start]-[Control Panel]-[Administrative Tools]-[Event Viewer].

 

Variable description

Italic texts in the messages denote variables and vary depending on the situations where the messages are output. The following table shows variables and the descriptions.

[Table B_3: Variable description]

Variable name	Description
disk	Mirror disk name
entryN	EFI boot entry name
group	Mirror group name

 

Severity

Service messages are categorized into the following four types listed from higher to lower severity.

[Table B_4: Severity]

Message number	Severity	Description
40XXX	STOP	This type of message is output when an event that causes the service to pause was detected.
42XXX	ERROR	This type of message is output when an event that causes part of the service to pause was detected.
44XXX	WARNING	This type of message is output to give warning when an error that does not cause the service to pause was detected.
46XXX	INFO	This type of message is output to track service activities.

---

B.2.1 Service Stop Messages (40XXX)

B.2.2 Service Error Messages (42XXX)

B.2.3 Service Warning Messages (44XXX)

B.2.4 Service Information Messages (46XXX)