Interstage Shunsaku Data Manager Operator's Guide - Microsoft(R) Windows(R) 2000/ Microsoft(R) Windows Server(TM) 2003 - - UNIX -

3.2.2 Stopping Shunsaku

This section explains how to stop Shunsaku.

Use the following procedure to stop the director server, search servers, any additional director servers, and the sort servers where the conductor is located.

[Figure : Shunsaku Stop Procedure]

*1) A search server connected to a director server where the conductor is located.
*2) A search server connected to an additional director server.

Execute the shunsysstop command on the director server, search servers, any additional director servers, and sort servers where the conductor is located.

To stop Shunsaku, execute the shunsysstop command on all servers in the same way.

shunsysstop -n Shunsaku system name

The following explanation applies when a multi-server configuration is in place. Users of systems that operate on a single server or systems in which searchers run on separate servers should only read the sections relevant to their configuration.

If an abnormality occurs during the stop process and Shunsaku fails to stop, the shunsysstop command will simply terminate. Refer to the error message displayed, eliminate the cause of the error, and then execute the command again. Refer to the Messages for more information about errors.

If a transaction is running when Shunsaku is stopped, the behavior will depend on how Shunsaku is stopped.

Stop method	Behavior when Shunsaku is stopped
Stopped normally	Shunsaku will wait until the transaction finishes and then stop.
Stopped forcibly	Shunsaku will roll the transaction back and then stop.