PRIMECLUSTER Installation and Administration Guide 4.2 (Linux for Itanium)

G.1.3 Posting Notification of a Resource Failure or Recovery

Details on incompatibilities

If a failure occurs in the resource or if the resource recovers from a failure, the failure or recovery of the resource can be posted by sending the message shown below to syslogd. The default setting at installation is that notification of a resource failure or recovery is not posted with PCL4.1A30. For details, see "Setting Up Fault Resource Identification and Operator Intervention Request."

Message No	Message overview
2700	Recovering from a resource failure
2701	Recovering from a node failure
6750	Resource failure
6751	Node failure

Changes

Before upgrading

Notification of a resource failure or recovery will be posted.

After upgrading

A resource failure or recovery will be posted only when the AppWatch parameter is set to ON with clsetparam. The default value of AppWatch at cluster installation is OFF and notification of the resource failure or recovery will not be posted.

Note

After you have changed the AppWatch parameter with clsetparam, you have to reboot all the nodes to validate the setting.