| PRIMECLUSTER Installation and Administration Guide 4.2 (Linux for Itanium) |
|
Contents
Index
|
| Part 2 Installation | > Chapter 4 Preparation Prior to Building a Cluster | > 4.3 Preparations for Starting the Web-Based Admin View Screen | > 4.3.3 Initial Setup of Web-Based Admin View |
When using Web-Based Admin View for the first time, you need to initialize the management server on each node. Take the following steps in the order listed below.
Operation Procedure:Stop Web-Based Admin View on all the management servers and nodes.
# /etc/init.d/fjsvwvcnf stop
# /etc/init.d/fjsvwvbs stop
Set the IP addresses of the primary management server and secondary management server.
Execute the following command on all the management servers and nodes, referring to the example.
# /etc/opt/FJSVwvbs/etc/bin/wvSetparam primary-server <primary-management-server-IP-address>
# /etc/opt/FJSVwvbs/etc/bin/wvSetparam secondary-server <secondary-management-server-IP-address>
Example: Set the "primary management server IP" and "secondary management server IP" of the "operation management mode" found on the Cluster Configuration Worksheet.
# /etc/opt/FJSVwvbs/etc/bin/wvSetparam primary-server 10.20.30.40
# /etc/opt/FJSVwvbs/etc/bin/wvSetparam secondary-server 10.20.30.41
Start Web-Based Admin View on all the management servers and nodes.
# /etc/opt/FJSVwvbs/etc/bin/wvCntl start
# /etc/init.d/fjsvwvcnf start
Web-Based Admin View has some different operation management modes. For further details, see "1.2.2 System topology" and "Chapter 7 Web-Based Admin View setup modification" in the "PRIMECLUSTER Web-Based Admin View Operation Guide."
|
Contents
Index
|