| PRIMECLUSTER Global File Services Configuration and Administration Guide 4.2 (Solaris(TM) Operating Environment) |
|
Contents
Index
|
| Appendix A Kernel Messages |
A.1.1 NOTICE: sfxfs:0001: mount_point: file system fullA.1.2 NOTICE: sfxfs:0002: mount_point: out of inodesA.1.3 NOTICE: sfxfs:0003: mount_point: file system meta-data full (Vdata) type = numberA.1.4 NOTICE: sfxfs:0004: mount_point: too much fragment (extent)A.1.5 WARNING: sfxfs:0005: mount_point: daemon create failedA.1.6 NOTICE: sfxfs:0010: illegal mode (recovered): mount_point | ino_num mode = file_modeA.1.7 NOTICE: sfxfs:0011: illegal free inode (recovered): mount_point | ino_num had size sizeA.1.8 NOTICE: sfxfs:0012: illegal mode (recovered): mount_point | ino_num mode = file_modeA.1.9 NOTICE: sfxfs:0013: illegal mode (recovered): mount_point | ino_numA.1.10 NOTICE: sfxfs:0014: illegal inode (recovered): mount_point | ino_num new size = size blocks = blocksA.1.11 PANIC: sfxfs:0015: mount_point: bad v_count == 0A.1.12 PANIC: sfxfs:0016: mount_point: bad v_count == 0A.1.13 NOTICE: sfxfs:0020: mount_point: bad namelen == 0 parent ino = numberA.1.14 PANIC: sfxfs:0021: mount_point: illegal operation: op = codeA.1.15 WARNING: sfxfs:0022: mount_point: bad dir ino number at offset offset: infoA.1.16 WARNING: sfxfs:0023: mount_point: target directory link count < 2 ino = numberA.1.17 WARNING: sfxfs:0024: mount_point: invalid offset offset ino = numberA.1.18 PANIC: sfxfs:0025: mount_point: invalid slot status codeA.1.19 NOTICE: sfxfs:0026: mount_point: bad namelen == 0 parent ino = numberA.1.20 WARNING: sfxfs:0027: mount_point: bad dir, ino = numberA.1.21 WARNING: sfxfs:0030: mount_point: meta-data read error. type = number dev = dev_num block = block_num size = sizeA.1.22 WARNING: sfxfs:0031: mount_point: meta-data read error. type = number dev = dev_num block = block_num size = sizeA.1.23 WARNING: sfxfs:0032: mount_point: bitmap read error. type = number dev= dev_num block = block_num size = sizeA.1.24 WARNING: sfxfs:0033: mount_point: bitmap read error. type = number dev = dev_num block = block_num size = sizeA.1.25 WARNING: sfxfs:0034: mount_point: bitmap read error. type = number dev = dev_num block = block_num size = sizeA.1.26 WARNING: sfxfs:0035: mount_point: bitmap write error. information was lost. type = number dev = dev_num block = block_num size = sizeA.1.27 WARNING: sfxfs:0036: mount_point: bitmap write error. type = number dev = dev_num block = block_num size = sizeA.1.28 WARNING: sfxfs:0037: mount_point: meta-data write error. type = number dev = dev_num block = block_num size = sizeA.1.29 WARNING: sfxfs:0038: mount_point: fail to update super block at first time dev = dev_num block = block_num size = sizeA.1.30 WARNING: sfxfs:0039: mount_point: bitmap write error. information was lost. type = number dev = dev_num block = block_num size = sizeA.1.31 WARNING: sfxfs:0040: mount_point: meta-data write error. information was lost. type = number dev = dev_num block = block_num size = sizeA.1.32 NOTICE: sfxfs:0041: mount_point: I/O error on log: dev = dev_num block = block_num size = size error = numberA.1.33 WARNING: sfxfs:0042: mount_point: LOG daemon is dead. dev = dev_numA.1.34 WARNING: sfxfs:0043: mount_point: super block write error. dev = dev_num block = block_num size = sizeA.1.35 WARNING: sfxfs:0044: mount_point: super block write error. information was lost. dev = dev_num block = block_num size = sizeA.1.36 WARNING: sfxfs:0045: mount_point : cannot access: too many I/O errors. dev = dev_numA.1.37 WARNING: sfxfs:0046: mount_point : cannot access: too many I/O errors. dev = dev_numA.1.38 NOTICE: sfxfs:0050: setting sfxfs_ninode to max value of valueA.1.39 NOTICE: sfxfs:0051: freeing wrong file system by umount file_numA.1.40 PANIC: sfxfs:0052: v_count != 0 ino_pointer ino_numA.1.41 PANIC: sfxfs:0053: mount_point: illegal transaction buffer. bufno = numberA.1.42 PANIC: sfxfs:0054: mount_point: illegal transaction buffer. bufno = numberA.1.43 PANIC: sfxfs:0055: mount_point: buffer overflow. size = sizeA.1.44 PANIC: sfxfs:0056: mount_point: hold count is invalid. type = number number = numberA.1.45 PANIC: sfxfs:0057: page_create == NULLA.1.46 PANIC: sfxfs:0058: bn == SFXFS_HOLEA.1.47 PANIC: sfxfs:0059: bn == SFXFS_HOLEA.1.48 NOTICE: sfxfs:0060: mount_point: read only mount, but modified (recovered):A.1.49 PANIC: sfxfs:0062: bn == SFXFS_HOLE and rw == S_WRITEA.1.50 WARNING: sfxfs:0063: mount_point: cannot delete extent. ino = number len = len width = width length = lenA.1.51 WARNING: sfxfs:0064: mount_point: no extent exists. ino = number osize = len len = lenA.1.52 WARNING: sfxfs:0065: mount_point: cannot delete extent. ino = number len = len width = width length = lenA.1.53 WARNING: sfxfs:0070: mount_point: super block read error. dev = dev_numA.1.54 WARNING: sfxfs:0071: mount_point: primary super block read failed, but secondary read. dev = dev_num block = block_num size = sizeA.1.55 WARNING: sfxfs:0072: mount_point: secondary super block read failed, but primary read. dev = dev_num block = block_num size = sizeA.1.56 NOTICE: sfxfs:0073: mount_point: VTOC read error. dev = dev_numA.1.57 WARNING: sfxfs:0074: mount_point: primary and secondary super blocks are different. dev = dev_numA.1.58 WARNING: sfxfs:0075: mount_point: partition configuration read error. dev = dev_numA.1.59 WARNING: sfxfs:0076: mount_point: primary partition configuration read failed, but secondary read. dev = dev_num block = block_num size = sizeA.1.60 WARNING: sfxfs:0077: mount_point: secondary partition configuration read failed, but primary read. dev = dev_num block = block_num size = sizeA.1.61 WARNING: sfxfs:0078: mount_point: primary and secondary partition configurations are different. dev = dev_numA.1.62 NOTICE: sfxfs:0079: mount_point: nodename mismatch. node <-> nodeA.1.63 WARNING: sfxfs:0080: mount_point: node information not found for nodeA.1.64 WARNING: sfxfs:0081: mount_point: super blocks differ. dev dev_num to dev_numA.1.65 WARNING: sfxfs:0082: mount_point: partition configuration differ. dev dev_num to dev_numA.1.66 sfxfs:0083: mount_point : over file hard limit (pid pnum, uid unum)A.1.67 sfxfs:0084: mount_point : Warning: too many files (pid pnum, uid unum)A.1.68 sfxfs:0085: mount_point : over file and time limit (pid pnum, uid unum)A.1.69 sfxfs:0086: mount_point : over hard disk limit (pid pnum, uid unum, inum ino)A.1.70 sfxfs:0087: mount_point : Warning: over disk limit (pid pnum, uid unum, inum ino)A.1.71 sfxfs:0088: mount_point : over disk and time limit (pid pnum, uid unum, inum ino)A.1.72 WARNING: sfxfs:0089: mount_point : segmap_release write error. addr = addr, offset = offset, error = error, ino = inoA.1.73 WARNING: sfxfs:0100: mount_point : cannot find specified volume information in partition configuration. dev = dev_numA.1.74 NOTICE : sfxfs:0110: tunename is too small (num1). Setting num2A.1.75 NOTICE : sfxfs:0111: tunename is too big (num1). Setting num2A.1.76 NOTICE : sfxfs:0112: mount_point : tunename is too small (num1). Setting num2A.1.77 NOTICE : sfxfs:0113: mount_point : tunename is too big (num1). Setting num2A.1.78 WARNING : sfxfs:0120: mount_point : meta data cache grow failed because of size limitationA.1.79 WARNING: sfxfs:0123: mount_point: meta data information is invalid. inode: ino volno: volno blkno: blkno detail: hexcodeA.1.80 WARNING: sfxfs:0124: mount_point: meta data information is invalid. volno: volno blkno: blkno detail: hexcodeA.1.81 WARNING: sfxfs:0125: mount_point: meta data information is invalid. inode: ino off: offset volno: volno sblkno: blkno eblkno: blkno detail: hexcodeA.1.82 WARNING: sfxfs:0126: mount_point: meta data information is invalid. inode: ino volno: volno blkno: blkno size: fsize iext: niext detail: hexcodeA.1.83 WARNING: sfxfs:0127: mount_point: meta data information is invalid. inode: ino volno: volno blkno: blkno magic: hexmagic branch: nentry detail: hexcodeA.1.84 WARNING: sfxfs:0128: mount_point: meta data information is invalid. volno: volno blkno: blkno branch: nentry detail: hexcode|
Contents
Index
|