Machine Administration Guide 2.6

4.36 setfanlife (1M)

Name

setfanlife - Fan life monitoring display/setting command

Format

/usr/sbin/FJSVmadm/setfanlife fan_name [hours | -i | -d]

Function

Sets fan life monitoring and displays the power-on time.

Option

The options are:

fan_name

Specify the target fan name.
Specify a fan name in the following form:
Fan for the base cabinet: FAN#n
FEP of the base cabinet: FEPFAN#n
Fan for an expansion cabinet: rci-address-FAN#n
FEP for an expansion cabinet: rci-address-FEPFAN#n
n is an identification number.
If you specify only a fan name, the system displays the power-on time of the specified fan.

hours

Specify the power-on time of the specified fan.
If you replace a fan with a new fan, specify 0.
If you install ESF again, the power-on time of a fan becomes 0.
Before you install the main unit again, set the power-on time.

-i

When you replace a fan, specify the fan name and initialize the monitoring information using this parameter.

-d

If you remove a fan, specify the fan name and delete the life monitoring information using this parameter.

Example of use

The following shows an example of setting the power-on time of FAN#0.

# /usr/sbin/FJSVmadm/setfanlife FAN#0 0

The following shows an example of the power-on time of FAN#2 installed on a cabinet whose RCI address is 003001ff.

# /usr/sbin/FJSVmadm/setfanlife 003001ff-FAN#2
003001ff-FAN#2  100  hours

End status

The end status can be:
0: Normal end
Other than 0: Error