Enhanced Support Facility 2.6 User's Guide

1.2.2 Shutdown

The system shuts down when you press the POWER switch on the processing unit's operation panel. When you press the POWER switch, you will normally see the following message:

• GP7000F model 200/200R/400/400A/400R/600/600R
• PRIMEPOWER 1/200/250/400/450/600

  pwrctrld: Power switch is pressed.  Press power switch again within 5 seconds to start shutdown procedure.

  
  

• GP7000F model 1000/2000
• PRIMEPOWER 800/1000/2000

  pwrctrld: Power switch is pressed.  Press power switch again within 30 seconds to start shutdown procedure.

  
  

Pressing the POWER switch again within the displayed seconds initiates the shut down process that stops the system and turns off power.

For the following models, when the POWER switch is pressed, the following messages are displayed in operation panel. However, nothing is displayed in the console.

• PRIMEPOWER 650/850/900/1500/2500/HPC2500

  POWER OFF OK?

  
  

For more information on shutting down the system using the POWER switch, refer to "1.3.2.1 POWER Switch Settings." Note that you can also shut down the system using the shutdown (1M) command.