PRIMECLUSTER Global Link Services Configuration and Administration Guide: Redundant Line Control Function 4.1 (for Solaris(TM) Operating System)
Contents Index PreviousNext
Appendix D Notice of supplemental information> D.2 Trouble shooting> D.2.6 Failure occurs while using IPv6 address (In the case of a Cluster system)

D.2.6.1 Fails to activate IPv6 takeover address

Phenomenon:

Outputs the following message and fails to activate IPv6 takeover IP address.

ifconfig: Duplicate address detected on link hme1 for address fec0:1380::100. Code 1

Cause and how to deal with:

If an IPv6 address is overlapping with the other systems, when attempting to activate an interface, the address overlap detection function causes to stop the activation of a takeover IP address. Be sure to check the other systems for over lapping IP addresses.

Contents Index PreviousNext
All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005