PRIMECLUSTER Global Link Services Configuration and Administration Guide: Redundant Line Control Function 4.1 (for Solaris(TM) Operating System)

C.3.2.5 dsppoll command

[Contents]

This command displays polling information of each virtual interface on Router/HUB monitoring function. This command only displays polling parameters of one virtual interface.

[Changes]

Before modification

This command did not display the polling parameters of each virtual interface.

The polling status would be displayed as follows.

After modification

Now, this command displays the polling parameters of each virtual interface.

The polling status would be displayed as follows.

[Notes]

• If you are using an application that references the output of dsppoll command, you must be aware that the output will be different. However, adding '-n' command allows outputting the polling parameter of each virtual interface in the same format before the modification.
• In the case of displaying polling target's parameters using '-c' option (as it has been the usual way of displaying the polling parameter), there are no changes made.