PRIMECLUSTER Global Link Services Configuration and Administration Guide: Redundant Line Control Function 4.1 (for Solaris(TM) Operating System)
Contents Index PreviousNext
Chapter 3 Environment configuration> 3.5 Deleting configuration information

3.5.3 Fast switching/RIP mode

The following shows the procedure for deleting configuration information:

  1. Stop the router/HUB monitoring function using the "hanetpoll off" command (only if the router/HUB monitoring function is used). For information, see Section "7.7 hanetpoll Command".
  2. Inactivate the concerned virtual interface using the "stphanet" command. For information, see Section "7.3 stphanet Command".
  3. Delete the concerned monitoring destination information (only if the router/HUB monitoring function is used). For information, see Section "7.7 hanetpoll Command".
  4. Delete the configuration information of the concerned virtual interface. For information, see Section "7.1 hanetconfig Command".
  5. Delete the /etc/hostname.interface file, and the host name defined as the /etc/inet/hosts file.
Contents Index PreviousNext
All Rights Reserved, Copyright (C) FUJITSU LIMITED 2005