PRIMECLUSTER Global Link Services Configuration and Administration Guide: Redundant Line Control Function 4.1 (for Solaris(TM) Operating System)

3.4.2 RIP mode

The following shows the procedure for changing configuration information for RIP mode:

1. Inactivate the concerned virtual interface using the "stphanet" command. For information, see Section "7.3 stphanet Command".
2. Stop the monitoring information (only if monitoring is enabled). For information, see Section "7.7 hanetpoll Command".
3. Change the configuration information.
4. After changing the configuration information, activate the concerned virtual interface using the "strhanet" command.
5. Start monitoring (only if monitoring is enabled). For information, see Section "7.7 hanetpoll Command".

The following lists the information that can be changed for RIP mode. No information can be changed besides the information listed below. Delete the concerned definition and add it again.

• Configuration definition information
  Use the "hanetconfig" command to change the following information. For information, see Section "7.1 hanetconfig Command".
  • Operation mode (Only RIP mode or Fast switching/RIP mode can be selected.)
  • Host name or IP address to be attached to a virtual interface or a logical virtual interface
  • Interface names to be bundled by a virtual interface
• Data of monitored remote system and parameters
  Use the "hanetpoll" command to change the following information. For information, see Section "7.7 hanetpoll Command".
  • Monitored remote system data (primary monitored remote system IP address and secondary monitored remote system IP address)
  • Monitoring interval
  • The number of monitoring times
  • The number of retries prior to stopping monitoring the router
  • Recovery monitoring period
  • Cluster switching
  • Link up waiting time