PRIMECLUSTER Global Link Services Configuration and Administration Guide: Multipath Function (for Solaris(TM) Operating Environment) |
Contents
![]() ![]() |
Chapter 4 Operation | > 4.1 Start and Stop of Multipath Function |
The Multipath Function is automatically terminated at system termination.
To stop all the configured interfaces, use the mpnetinit command. To stop a specific interface, use the mpnetconfig command. For details, please refer to "6.1.1 mpnetinit command" and "6.1.2 mpnetconfig command."
![]()
- To terminate all interfaces, stop the high-layer protocols that use the interfaces first, before executing the command.
To terminate specific interfaces, stop the high-layer protocols that use the target interface before executing the command. Whether the high-layer protocol for each interface can be terminated or all interfaces are terminated depends on the command specification of the high-layer protocol.
For TCP/IP interface, The mpnet_ifinit command or the mpnet_ifconfig command can be used.- When using a system as the NFS server, the Multipath Function cannot be stopped using these commands.
Contents
![]() ![]() |