PRIMECLUSTER Global File Services Configuration and Administration Guide 4.1 (Linux)
Contents Index PreviousNext

Appendix A List of Messages> A.2 GFS Shared File System Daemon messages> A.2.2 Error messages

A.2.2.1 sfcfrmd daemon


 

ERROR: sfcfrmd:0001: not superuser

[Explanation]

sfcfrmd is not performed by superuser

[Response]

Please start sfcfrmd by sfcfrmstart command as a superuser.


 

ERROR: sfcfrmd:0002: associated with a terminal device

[Explanation]

The direct module is performed.

[Response]

Please start by sfcfrmstart.


 

ERROR: sfcfrmd:0003: cannot read pathname, or something wrong

[Explanation]

Since there was injustice or file reading of pathname went wrong, sfcfrmd starting went wrong.

[Response]

Please check whether the file of pathname is set up correctly.


 

ERROR: sfcfrmd:0004: cannot get node version string

[Explanation]

Since the version information on string could not be acquired, sfcfrmd starting went wrong.

[Response]

Make sure that /var/opt directory has a space by df(1) command and re-start the node.


 

ERROR: sfcfrmd:0005: something wrong in pathname

[Explanation]

Since setting injustice was in pathname, sfcfrmd starting went wrong.

[Response]

Please check whether a setup of pathname is right.


 

ERROR: sfcfrmd:0006: cannot allocate memory space

[Explanation]

Since acquisition of a memory went wrong, sfcfrmd starting went wrong.

[Response]

Please check the state of a system, and wait for the end of other processes, or increase and reboot a swap domain.


 

ERROR: sfcfrmd:0007: cannot start service

[Explanation]

sfcfrmd starting went wrong.

[Response]

Collect the diagnostic data with "/opt/FJSVsfcfs/sbin/sfcsnap.sh -c output_dir" and pclsnap in all the nodes, and contact your local Customer Support.


 

ERROR: sfcfrmd:0008: I/O error or data corruption of management partition: pathname

[Explanation]

sfcfrmd failed in reading and writing of pathname.

[Response]

Please check whether a setup as a management partition domain of the GFS Shared File System is right, or a disk operates normally.


 

ERROR: sfcfrmd:0009: something wrong in cluster settings

[Explanation]

Since a cluster was not started, sfcfrmd starting went wrong.

[Response]

Please start a cluster.


 

ERROR: sfcfrmd:0010: cannot get host name

[Explanation]

The host name was not able to be acquired.

[Response]

Please check a setup of an IP address.


 

ERROR: sfcfrmd:0011: cannot connect to sfcprmd

[Explanation]

Connection with sfcprmd went wrong.

[Response]

Please check whether sfcprmd is started.


 

ERROR: sfcfrmd:0012: cannot connect to sfchnsd

[Explanation]

Connection with sfchnsd went wrong.

[Response]

Please check whether sfchnsd is started.


 

ERROR: sfcfrmd:0013: cannot activate sfchnsd

[Explanation]

sfchnsd is not activated.

[Response]

Collect the diagnostic data with "/opt/FJSVsfcfs/sbin/sfcsnap.sh -c output_dir" and pclsnap, and contact your local Customer Support.


 

ERROR: sfcfrmd:0014: cannot get service port

[Explanation]

A service port is not able to be acquired.

[Response]

Please check whether service is set as /etc/services.


 

ERROR: sfcfrmd:0015: cannot get limit of newly created descriptor

[Explanation]

The maximum value of file descriptor generation was not able to be acquired.

[Response]

Please check the maximum value of a file descriptor.


 

ERROR: sfcfrmd:0019: no node information on special

[Explanation]

The node information for this node is not registered into the management partition special.

[Response]

Register the node information using sfcsetup command.


Contents Index PreviousNext

All Rights Reserved, Copyright(C) FUJITSU LIMITED 2004