REMCS Agent Operator's Guide 1.5

3.8.2 Sending investigation information to REMCS Center

The following notes are on sending the investigation information to the REMCS Center.

[Checking the connection status]

To send investigation information to the REMCS Center, confirm that a connection to REMCS Center is already established. It can be checked by selecting [REMCS Operation] from the " Remote Setup" menu.

[Note]

For the UNIX Server model that uses System Console, a message indicating the non-connection state with the REMCS Center is not displayed even if you are going to send a investigation information. To send investigation information, confirm that a connection with the REMCS Center is established by using the [REMCS Operation Setting] menu on the console side.

[Number of investigation information to be sent]

When investigation information is sent, the following three kinds of data are sent, at a minimum.

• Investigation information actually selected

• Collection results log

• Software configuration information

• Save area information